Marmox Fiber Mesh Roll
Marmox Fiber Mesh Roll
Marmox Fiber Mesh Roll (25 m x 10 cm) is a high tensile, self-adhesive alkali resistant fiberglass mesh tape designed for structural joint reinforcement across Marmox board installations.
Technical Property | Official Certified Value | Engineering Benefit |
Base Material | Alkali-Resistant (AR) Fiberglass Mesh | Prevents chemical degradation in high-alkaline cement environments |
Dimensions | Length: 25 meters | Width: 10 centimeters | Optimal width for continuous and secure board joint bridging |
Adhesive Property | Self-Adhesive Backing | Enables rapid, tool-free direct placement onto Marmox boards |
Tensile Performance | High tensile strength & dimensional stability | Eliminates joint reflection cracking under dynamic building loads |
Self-Adhesive Convenience: Sticks instantly to clean board surfaces without needing pre-applied adhesive.
Alkali Resistant (AR): Fully protected against chemical degradation from tile adhesives and cement mortars.
Crack Prevention: Reinforces board joints against micro-movements caused by thermal expansion or structural shifts.
Ultra-Thin Profile: Keeps joint buildup minimal to maintain a flat, level surface for tiling.
High System Compatibility: Integrates seamlessly with Marmox adhesives, liquid membranes, and cement slurries.
Marmox Board Joint Reinforcement: Bridging longitudinal and transverse joints between wall/floor Marmox boards.
Corner & Edge Reinforcement: Securing internal and external wall joints in wet rooms, spa areas, and bathrooms.
Pre-Tiling Substrate Prep: Protecting tile installations from underlying joint cracks and structural stresses.
Board Partition Stabilizing: Reinforcing joints in lightweight partition systems and drywall assemblies.
Substrate Preparation: Ensure Marmox board surfaces are completely dry, clean, and free of dust or debris.
Mesh Application: Unroll Marmox Fiber Mesh Roll directly along the center of the joint and press firmly into place.
Bedding & Encapsulation: Apply a thin layer of tile adhesive or Marmox sealant over the mesh using a trowel.
Smoothing: Smooth out the adhesive coat to ensure the mesh is fully embedded and flush with the board surface.
