Marmox Thermoblock Nano

Compressive Strength: High load capacity of 9.0 - 10.0 N/mm²

• Engineering Benefit: Safely supports load-bearing walls at the starter course without structural compromise.

Thermal Conductivity (λ Value): Ultra-low thermal conductivity of 0.050 W/mK

• Engineering Benefit: Fully eliminates thermal cold bridges between foundations and building walls.

Facing & Bonding Layer: Polymer-modified cement mortar with GRP mesh

• Engineering Benefit: Provides superior mechanical bonding with standard bricklayers' mortar.

Moisture & Water Resistance: Water absorption < 3.5% and 100% moisture resistant

• Engineering Benefit: Acts as an effective damp-proof barrier preventing rising dampness and condensation.

Fire Resistance: Certified fire resistance exceeding 120 minutes (BS EN 1365-1)

• Engineering Benefit: Maintains structural safety and strictly complies with international building fire codes.

Complete Thermal Bridge Elimination: Prevents heat loss and cold transmission at wall base junctions.

High Structural Load Capacity: Nano-composite reinforced concrete columns withstand high compressive wall loads.

Damp-Proofing Protection: Effectively halts capillary action and rising damp from foundation slabs.

Standard Masonry Installation: Installed easily as a starter course using conventional cement-sand mortar.

Easy Cutting & Customization: Can be effortlessly cut on-site using a brick saw to fit corners and junctions.

Wall Base Starter Course: Placed as the first course in inner and outer leaves to connect floor and cavity insulation.

Energy Efficient & Green Buildings: Ideal structural solution for reducing building heating and cooling energy consumption.

Slab Edge & Foundation Junctions: Creates a continuous insulation envelope between floor slabs and perimeter walls.

Damp & Moisture Prone Structures: Protects walls from paint peeling and efflorescence caused by foundation moisture.

Substrate Preparation: Ensure foundation beam or slab surface is clean, level, and free of loose material.

Mortar Bedding: Apply a uniform layer of standard cement-sand bricklaying mortar onto the base.

Block Laying: Lay Marmox Thermoblock Nano blocks tightly as the first course, pressing gently into the mortar bed.

Joint Sealing: Ensure tight vertical butt joints between blocks to maintain a continuous insulation line.

Masonry Continuation: Proceed directly with laying standard bricks or AAC blocks over the Thermoblock course.