Conflow BR

Technical Property,Official Certified Value,Engineering Benefit

Classification,Water Reducing & Set-Retarding Admixture (Type G),Delays hydration rate while enhancing plastic flowability

Set Delay Control,Extended Initial & Final Setting Windows,Prevents cold joints between consecutive concrete pours

Water Reduction,15% - 20% Reduction in Mix Water (W/C Ratio),Significantly increases long-term compressive strength & density

Chloride Content,Completely Chloride-Free Composition,100% safe for prestressed and heavily reinforced structural steel

Cohesiveness Profile,Anti-Bleeding & Segregation Resistant (easydeal),Maintains homogenous aggregate suspension during long transportation

• Hot-Weather Concreting Solution: Mitigates rapid slump loss, flash setting, and drying cracking caused by high ambient temperatures.

• Extended Workability Window: Grants site engineers ample time for pumping, placing, and compacting large volume concrete pours smoothly.

• Cold Joint Elimination: Delivers seamless monolithic bonding between successive concrete layers during continuous pouring.

• Hydration Heat Control: Reduces peak thermal hydration temperatures, preventing thermal stress micro-fissuring in mass concrete foundations.

• High Ultimate Strength: Low W/C ratio yields a dense, impermeable concrete matrix with low water absorption for 2026 standards.

• Mass concrete elements such as raft foundations, heavy retaining walls, dams, and thick piers.

• Ready-mix concrete batching requiring extended transit times or long queuing hours in hot weather across Egypt.

• Bridge decks, tunnels, and water containment infrastructure requiring seamless casting and high density.

• Summer slab casting under direct sunlight and high-wind environments using easydeal solutions.

• Dosage Assessment: Recommended dosage typically ranges between 0.4% and 1.5% by weight of cementitious material, determined via jobsite trial mixes based on target delay and temperature.

• Addition Procedure (easydeal method): Dispense Conflow BR directly into the mixing water or add directly into the transit mixer drum alongside the final portion of batching water.

• Mixing Duration: Mix thoroughly at maximum speed for at least 3 minutes to guarantee complete distribution within the batch.

• Jobsite Caution: Do not add to dry cementitious components. Ensure prompt wet-curing or apply an acrylic curing membrane immediately following initial set.