Kematone Deluxe Putty

Outstanding Mechanical Anchoring: Forms a permanent bond with underlying cementitious matrices, entirely eliminating risks of future flaking, delamination, or blistering.

Shrinkage-Free Matrix: Infused with intrinsic polymer elasticity that completely counteracts drying shrinkage cracks, even when applied at varied depths.

High-Build Void Filling: Efficiently eliminates concrete honeycombing, surface deviations, and plaster imperfections in a single mechanical pass.

Controlled Absorption Regulation: Balances surface suction uniformly, drastically minimizing the consumption and waste of subsequent latex and emulsion topcoats.

Safe Low-VOC Formulation: Water-based composition completely free from pungent organic solvents, allowing safe indoor application in enclosed areas.

Leveling, skimming, and smoothing internal structural concrete, masonry walls, and ceilings (applicable for protected exterior surfaces).

Filling, jointing, and treating joints, fasteners, and surfaces of internal gypsum board systems and suspended ceilings.

Restoring weathered, stripped architectural walls during renovation phases to rebuild surface structural integrity.

Eradicating surface plaster map cracks and structural micro-fissures to create a mathematically level substrate (Zero-Leveling).

Substrate Preparation: Substrates must be completely dry, clean, fully cured, and free from dust, loose rendering, or shuttering oils. Priming the substrate with a water-based sealer (such as Hanza Seal or Nano Sealer) is highly recommended to regulate absorption.

Application Protocols: Apply Kematone Deluxe Putty straight from the bucket without water addition using professional stainless steel trowels or putty knives. Apply two cross-directional coats (vertical and horizontal) to secure perfect flatness tracking.

Sandability Phase: Allow the applied putty matrix to dry fully for 4 to 6 hours. Sand the surface using fine-grit sandpaper (No. 150 or 220) to achieve the required finish profile.

Dust Clearance & Priming: Thoroughly clean all sanding dust using a clean brush or compressed air, then apply a stabilizing primer coat prior to the final architectural paint application.